[2026] Network Appliance NetApp Certified 7-Mode Data Administrator

문제1

Which statement is true about ASIS deduplication license with Data ONTAP 8.1?

A. The license is capacity-based.

B. A new license key is generated.

C. The license no longer exists.

D. The existing 8.0 license key is used.

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제2

After issuing the aggr split aggr0/plex0 aggrNew command ____________.

A. there are two unmirrored aggregates, aggr0 and aggrNew

B. there is a new mirrored aggregate called aggrNew

C. there are two new plexes, plex0 and plexNew

D. there is a new plex called aggrNew

E. flexible volumes are evenly split between aggr0 and aggrNew

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제3

Which statement applies to the Open Systems SnapVault Free Space Estimator utility?

A. This utility determines if there is sufficient disk space available on the primary to perform an OSSV transfer.

B. This utility runs automatically after each transfer.

C. This utility determines if there is sufficient disk space available on the secondary to perform an OSSV transfer.

D. This utility must be enabled on the secondary storage system.

정답: A

문제4

For each Open Systems platform directory to be backed up to the SnapVault secondary storage
system you must execute _____________.

A. A temporary copy

B. An incremental copy

C. An initial baseline copy

D. A scheduled update copy

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제5

One method of configuring an interface for takeover is to enter ifconfig interface partner address at the command line. To make this configuration persistent across reboots, you must enter this information in the _____ file for each system.

A. /vol/vol0/home

B. /vol/vol0/mount

C. /etc/hosts

D. /etc/rc

정답: D

설명: (Fast2test 회원만 볼 수 있음)

문제6

To create a 64-bit aggregate, which optional switch/flag/parameter/option to the aggr create command must be included?

A. No optional switch/flag/parameter/option is needed because 64-bit aggregates are the default

B. b 64

C. L 64

D. l 64

E. B 64

정답: E

설명: (Fast2test 회원만 볼 수 있음)

문제7

Using the output below, a co-worker determined that these are types "Solaris" LUNs. What would your destination be?
lun show - m LUN patch mapped to LUN ID ------------------------------------------------------
/vol/vol1/lun0 solaris - igroup0 0 /vol/vol1/lun solaris- igroup1
0 /vol/vol1/qtree1/lun2 solaris - igroup2 0 /vol/vol1/qtree1/lun3 solaris - igroup3 0

A. These are type "Solaris" LUNs.

B. Not enough information is given here. Run the lun map command to get the information requested.

C. Not enough information is given here. Run the lun show -v command to get the information requested.

D. Not enough information is given here. Run the lun status command to get the information requested.

정답: C

문제8

Is NetApp storage Encryption supported in Data ONTAP 8.1.1 Cluster-Mode?

A. No, but you can file a PVR to request support.

B. No. it is targeted for a future release of Data ONATP.

C. Yes, it has been supported since 8.0.1.

D. Yes, only with a special license installed.

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제9

You are trying to do a single file SnapRestore for a file, but you are receiving an error message that the directory structure no longer exists. Which is the most likely explanation?

A. Snapshot copies have been created since the original directory structure was deleted.

B. You must recreate the directory structure before trying to restore the file.

C. You cannot restore a file to an alternate location.

D. Once the directory structure has been deleted, you cannot restore the file using single file SnapRestore. You must now SnapRestore the volume.

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제10

Which SyncMirror command mirrors an existing unmirrored aggregate where Data ONTAP selects the disk drive?

A. aggr mirror aggrT -d 12@144

B. aggr mirror aggrY

C. aggr mirror aggrY -m

D. aggr mirror aggrY -m 12@144

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제11

Which option will allow a storage system to SnapMirror from this source system?

A. options snapmirror.access host =

B. options snapmirror.allow host =

C. snapmirror.destination

D. snapmirror.access

정답: A

설명: (Fast2test 회원만 볼 수 있음)

Network Appliance NetApp Certified 7-Mode Data Administrator - NS0-155무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트