Citrix Implementing NetScaler 10 for Networking and Traffic Optimization - 1Y0-A28무료 덤프문제 풀어보기
Scenario: A NetScaler engineer configured a service and server for RADIUS authentication. To ensure that the RADIUS service is available and responding to authentication requests, the engineer has added the NetScaler built-in monitor to the service. On inspecting the RADIUS service the engineer notices it is marked as DOWN. What could be causing this issue?
정답: D
Scenario: An engineer executes the following commands: add vlan 2 bind vlan 2 -ifnum 1/2 add ns ip 10.110.4.200 255.255.255.0 bind vlan 2 -IPAddress 10.110.4.200 255.255.255.0 What type of IP address has been added to the NetScaler?
정답: A
Scenario: A network engineer has bound four policies to a virtual server as follows:
PolicyA has a priority of 10
PolicyB has a priority of 20
PolicyC has a priority of 30
PolicyD has a priority of 0
Which policy will be evaluated first?
PolicyA has a priority of 10
PolicyB has a priority of 20
PolicyC has a priority of 30
PolicyD has a priority of 0
Which policy will be evaluated first?
정답: C
What are two valid ways of checking that a back-end web server is reachable from the NetScaler SNIP address using port 80? (Choose two.)
정답: B,E
Scenario: An organization has recently been penetration-tested by a security company. The findings have indicated that the NetScaler device is responding to requests revealing web server information within the HTTP response headers. Which NetScaler feature can a network engineer use to prevent this information from being leaked to a potential malicious user?
정답: B
Scenario: An engineer has configured a virtual server that users access using HTTP port 80. The web application also uses TCP port 81 and 8080 for non-user access. The engineer would like to prevent users from connecting to web servers if any of the ports go down. How should the engineer set this configuration to ensure service availability?
정답: C
An engineer is checking that ports are configured correctly between the NetScaler system and a back-end web server. Which command should the engineer use to test that the web server is responding on port 80?
정답: C