Oracle Communications Session Border Controller 7 Basic Implementation Essentials - 1z0-404무료 덤프문제 풀어보기

A. A unique phy-interface configuration element is created for all signaling/media interfaces.

B. A phy-interface elementmust be configured for each interface used for High Availability
(HA) heartbeats, but not for signaling and/or media.

C. After configuring a phy-interface configuration element for signaling and/or media, a reboot of the Session Border Controller is required.

D. A phy-interface configuration element must be configured for each interface used.

E. A phy-interface configuration element for signaling and/or media hasthe operation-type parameter set to control.

A. The realm-id parameter value of the steering-pool refers to a realm-config element that does not exist in the configuration.

B. Another steering-pool configuration element with same ip-address, realm-id, start-port, and end-port parameters values already exists in the configuration.

C. Another steering-pool configuration element with same ip-address and realm-id but with different start-port and end-port parameters values already exists in the configuration.

D. The realm-id parameter value of the steering-pool refers to a realm-config element that already exists in the configuration.

E. The ip-address parameter of the steering-pool has the same value as the address parameter of a sip-port configuration element.

A. From superuser mode, execute the save-config and activate-config and reboot commands.

B. From configuration mode, execute the save-config, activate-config, and reboot commands.

C. From user mode, execute the save-config and activate-config commands.

D. From superuser mode, execute the save-config and activate-config commands.

E. From superuser mode, execute the save-config, activate-config, and reboot force commands.

A. The training6 peer is the active node.

B. The two nodes have different health scores.

C. The switchover berpd force commandwas executed to do a manual failover.

D. The training1 peer is the standby node.

E. The training6 peer will wait 1050 ms before considering the training1 peer out of service.

A. Community strings are in passive mode.

B. The default community strings are acme and packet.

C. The default community stringsare public and private.

D. There are no default community strings.

E. Only one trap receiver can be configured.

A. the virtual IP address and its hardcoded MAC address

B. the IP utility address and its virtual MAC address

C. the IP utility address andthe MAC utility address

D. the IP utility address and its hardcoded MAC address

E. the virtual IP address and its virtual MAC address

A. they provide routingfunctions for IP, TCP, and SMTP using application parameters.

B. they enable premium interactive services across IP network borders by complementing existing edge routers

C. they are session-aware devices that enable control of end-to-end interactive communications across PSTN network borders

D. they span multiple networks and provide edge proxy functions between them

E. they replace typical edge routers and firewalls in order to provide a unified network border for signaling and media control