Nokia Border Gateway Protocol Fundamentals for Services - 4A0-114무료 덤프문제 풀어보기

A. Either RSVP, LDP, or segment routing tunnels need to be established within each region.

B. Each PE router needs to advertise an IP address as a labeled BGP route to identify the tunnel endpoint.

C. MP-BGP address families label-ipv4 or label-ipv6 need to be supported on each of the edge routers.

D. Either RSVP, LDP, or segment routing tunnels need to be established between regions.

A. Well-known mandatory

B. Optional transitive

C. Well-known discretionary

D. Optional non-transitive

A. Edge and transit routers need to be configured with BGP.

B. A full mesh of iBGP peering sessions is not required,

C. The transit routers need to support LDP or RSVP-TE LSPs.

D. MPLS tunnels are used to carry transit traffic across the network.

A. The multihop parameter needs to be configured when eBGP peers are not adjacent to each other.

B. iBGP peers have to be adjacent to each other.

C. Peers need to be IP reachable to establish a BGP session.

D. Route reflectors can reduce the number of iBGP sessions required.

A. It carries an IP address and requests the MAC address of the corresponding host.

B. It carries a host MAC address and optionally the associated IP address that belongs to the same host.

C. It carries a host MAC address and optionally the IP prefix of the subnet where the host is located.

D. It carries an IP prefix and its associated mask.