[2026] Cisco Managing Industrial Networks with Cisco Networking Technologies

문제1

At which Layer would you check for spanning tree loops?

A. Layer 1

B. Layer 4

C. Layer 3

D. Layer 2

정답: D

문제2

EtherNet/IP is an Ethernet implementation of which protocol?

A. CIP

B. ControlNet

C. Industrial Protocol

D. DeviceNet

정답: A

문제3

Exhibit:

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?

A. These commands need to be added to the configuration:C-router(config)# router eigrp 123Crouter(config-router)# network 172.19.0.0

B. These commands need to be added to the configuration:C-router(config)# router ripCrouter(config-router)# network 172.19.0.0

C. No further routing configuration is required.

D. These commands need to be added to the configuration:C-router(config)# router ospf 1Crouter(config-router)# network 172.19.0.0 0.0.3.255 area 0

정답: C

문제4

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

A. duplex operating mode

B. BDPU priority

C. designated ports

D. root ports

E. fast mode ports

F. root bridge

정답: C,D,F

문제5

Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?

A. Switch(config-if-ind)#

B. Switch(config-line)#

C. Switch(config-ind)#

D. Switch(config-vlan)#

E. Switch(config-if)#

정답: E

문제6

What are two benefits that are provided by proper grounding and bonding systems? (Choose two.)

A. lower equipment power consumption

B. equipotential termination points for equipment and cable shields

C. safe discharge of electrostatic energy

D. lowest carbon footprint

E. higher speed communications

정답: B,C

문제7

Exhibit:

Refer to the exhibit. An industrial ruggedized network device needs to be installed in the place of the icon labeled Network Device to accommodate a leased line attachment to the Internet. Which network device and interface configuration meets the minimum requirements for this installation?

A. a router with two Ethernet interfaces

B. a router with one Ethernet and one modem interface

C. a router with one Ethernet and one serial interface

D. a switch with two Ethernet interfaces

E. a switch with one Ethernet and one serial interface

정답: C

Cisco Managing Industrial Networks with Cisco Networking Technologies - 600-601무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트