[2026] Avaya Ethernet Routing Switch Implementation

문제1

Consider the following deployment requirements
Support 40 100 Mb/s VoIP telephones, each with a power requirement of 6 Watt Support 40 directly connected 1000 Mb/s Ethernet workstations with UTP cable
Support four 1Gb/s Ethernet uplinks to the core switch using multimode fiber.
Which configuration is the minimum hardware required for an Ethernet Routing Switch (ERS) 8306 chassis that will support the above requirements?

A. Two 8348TX-PWR One 8393SF

B. Two 8348GTx-PWF One 8308XX One 8393SF

C. One 8348GTx One 8348Tx-PWR One 8393SF

D. One 8348GTx One 8348Tx-PWF One 8308 XL One 8393SF

정답: C

문제2

A technician is troubleshooting some IP telephones that arc connected to an Ethernet
Routing Switch (ERS) 8300 8348TX-PWR I/O module. the IP telephones will not turn on the 48V LED on the module has been checked and it is steady amber.
What does this indicate?

A. 48V is not available

B. PoE is disabled

C. Module is booting

D. 48V is present

정답: C

문제3

A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 lo a core pair of ERS 8600 switches.
Which statement about the correct uplink configuration is true?

A. Disable auto negotiation and replace it with VLACP to identify single fiber fault failure

B. Enable Spanning Tree Protocol for the MLT when using it with SMLT in the core of the network.

C. Distribute uplinks across different ERS 5500 switches in the stack.

D. Use unique MLT IDS for each stack of edge ERS 5500 switches

정답: C

문제4

The Ethernet routing switch (ERS) 5000 switches are being upgraded and it appears that a license is not recognized on the switch.
Which two statements are valid sources of information that will help resolve the license installation? (Choose two.)

A. Check to see if the MAC address is correct in the license file.

B. Check the record of MSG address changes

C. Use the show license file command to get the license installation status.

D. Check for an 'invalid license fife' log report

E. Use the show license command to get the license installation status

정답: A,E

문제5

What is the front panel port configuration for the Ethernet Routing Switch (ERS) 2550TPWR?

A. 48 10/100 BaseT ports (PoE on 48 ports) Two combo 10/100/1000BaseT or SFP port

B. 50 10/100BaseT ports (PoE on 25 ports) two combo 10/100/1000BaseT or SFP port

C. 50 10/100BaseT ports (PoE on 50 ports) two combo 10/100/1000BaseT or SFP port

D. 48 10/100BaseT ports (PoE on 24 ports) two combo 10/100/1000BaseT or SFP port

정답: D

문제6

In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, not green. What does this mean?

A. The port is set to operate at 10 Mbps.

B. It indicates that there is a transmit fault.

C. It indicates that the port is administratively disabled.

D. The port is set to operate at 100 Mbps.

정답: C

문제7

As stated in RFC 2338. (Virtual Router Redundancy Protocol) VRRP management problems can occur if the address used by the management station is used incorrectly.
Which two statements describe how to avoid management problems? (Choose two)

A. A VRRP interface MUST NOT accept packets addressed to the IP address (es) associated with the virtual router if it is not the IP address owner (priority = 255)

B. A VRRP interface MUST accept packets addressed to the IP address (es) associated with the virtual router if it is the IP address owner (priority = 255)

C. A VRRP interface MUST NOT accepts packets addressed to the IP address (es) associated with the virtual router if it is the IP address owner. (Priority=255)

D. A VRRP interface MUST accept packets addressed to the IP address (es) associated with the virtual router if it is not the IP address owner (priority = 255)

정답: A,B

Avaya Ethernet Routing Switch Implementation - 6101-1무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트