Cisco Building Cisco Service Provider Next-Generation Networks Part 2 - 640-878무료 덤프문제 풀어보기

A. VLAN MTU

B. native VLAN ID

C. VLAN name

D. VLAN map

E. VLAN ID

A. PHP is implemented to increase the performance on the LSR (P routers). PHP enables the LSR (P routers) to perform two lookups, first lookup based on the ingress label and a second route lookup based on the destination IP address.

B. PHP is implemented to increase the performance on the ingress edge LSR. PHP enables the ingress edge LSR to perform two lookups, first lookup based on the ingress label and a second route lookup based on the destination IP address.

C. PHP is implemented to increase the performance on the LSR (P routers). PHP enables the LSR (P routers) to perform only one lookup based on the ingress label.

D. PHP is implemented to increase the performance on the egress edge LSR. PHP allows the egress edge LSR to perform only one lookup to route the IP packet based on destination IP address and routing table.

E. PHP is implemented to increase the performance on the LSR (P routers). PHP enables the LSR (P routers) to perform only one route lookup based on the destination IP address.

F. PHP is implemented to increase the performance on the egress edge LSR. PHP enables the egress edge LSR to perform two lookups, first lookup based on the ingress label and a second route lookup based on the destination IP address.

G. PHP is implemented to increase the performance on the ingress edge LSR. PHP enables the ingress edge LSR to perform only one lookup based on the ingress label.

H. PHP is implemented to increase the performance on the egress edge LSR. PHP enables the egress edge LSR to perform only one lookup based on the ingress label.

A. mismatched OSPF router ID between the new router and the neighbor router

B. mismatched OSPF area ID between the new router and the neighbor router

C. mismatched interface bandwidth between the new router and the neighbor router

D. mismatched interface MTU between the new router and the neighbor router

E. mismatched OSPF authentication data between the new router and the neighbor router

F. mismatched OSPF hello/dead interval between the new router and the neighbor router

A. weight

B. local preference

C. MED

D. AS path

A. switchport access vlan 301

B. switchport mode access vlan 301

C. switchport mode trunk vlan 301

D. switchport vlan 301

A. Test1 refers to a route policy that is defined using the RPL.

B. The IBGP session is missing the mandatory route-policy configuration.

C. This router uses its Loopback 0 interface IP address when establishing BGP peering with the
10.2.1.1 router.

D. Both the IBGP and EBGP sessions will be authenticated.

E. This router uses its Loopback 0 interface IP address when establishing BGP peering with the
192.168.101.11 router.

A. The port must be an NNI type and must be in trunk mode.

B. If a failure occurs within the segment, the blocked port goes to the forwarding state

C. Ports are never blocked in a given segment

D. The rep segment number command is used to enable REP on the switch port.

E. A REP segment cannot be wrapped into a ring topology.

F. The port where the segment terminates is called the edge port.

A. IP routing

B. IP route 0.0.0.0 0.0.0.0 209.165.200.250

C. IP default-gateway 209.165.200.250

D. IP networking

E. IP routing 0.0.0.0 0.0.0.0 209.165.200.250