[2026] Cisco Introducing Cisco Data Center Networking

문제1

A network operations team needs to monitor the health of Cisco Nexus switches. Which type of UDP-based protocol should be configured on these devices for management and monitoring?

A. TELNET

B. SMTP

C. SNMP

D. SSH

E. FTP

정답: C

문제2

On most keyboards, the Up arrow and Down arrow keys move through the command history. Which two key sequences can be used as alternatives? (Choose two.)

A. Alt-F

B. Alt-A

C. Alt-P

D. Alt-N

E. Alt-E

정답: C,D

설명: (Fast2test 회원만 볼 수 있음)

문제3

What is the Cisco Nexus Operating System command to define a port as a Layer 3 port?

A. No switchport

B. l3 switchport

C. Port routed

D. Port switching off

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제4

Which network topology is most closely associated with FDDI?

A. token passing bus

B. star

C. extended star

D. bus

E. ring

정답: E

설명: (Fast2test 회원만 볼 수 있음)

문제5

Which version of Cisco Nexus Operating System became a common operating system for Cisco Nexus switches and Cisco MDS storage switches?

A. 6.2

B. 3.9

C. 3.3

D. 2.7

E. 5.01GD

F. 4.1

정답: F

설명: (Fast2test 회원만 볼 수 있음)

문제6

On which two components of a router can a copy of a running-configuration file be saved manually by an engineer for backup purposes? (Choose two.)

A. RAM

B. DRAM

C. NVRAM

D. Flash

E. ROM

정답: C,D

문제7

Refer to the exhibit.

Which hardware property of the bootup process can be determined about the router?

A. The router will stop at a boot loader prompt.

B. The router is set to automatically boot from bootflash on reloading.

C. The router is set to automatically boot from SATA disk on reloading.

D. The router has 4 GB of memory to store the startup configuration files.

E. The router has 32 MB of NVRAM to store the startup configuration files.

정답: B

문제8

VLAN 10 is assigned IP address 10.1.1.1 with subnet mask 255.255.255.0. Which configuration is used to route the IP subnet but not form OSPF neighbors on a Cisco Nexus 7000 switch?
A)

B)

C)

D)

A. Option C

B. Option D

C. Option A

D. Option B

정답: C

문제9

How many IP address ranges are specified in RFC 1918?

A. 1 in Class A, 16 in Class B, and 256 in Class C

B. 4 in Class A, 8 in Class B, and 16 in Class C

C. 1 in Class A, 2 in Class B, and 4 in Class C

D. 2 in Class A, 4 in Class B, and 8 in Class C

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제10

An engineer has implemented EIGRP in the data center with a large OSPF routed environment. All EIGRP routes were functioning properly until enabling EIGRP route summarization. Legacy OSPF routes are now being used for route selection. Why have the routes changed?

A. OSPF has a more specific route with EIGRP summarization enabled

B. EIGRP summary routes have a higher administrative distance than EIGRP specific routes

C. increase the administrative distance for the OSPF route process

D. modify the bandwidth and delay metrics to be preferential over OSPF

E. reduce the administrative distance for the EIGRP summarized routes

정답: B

문제11

What is the maximum distance that is supported between two devices that are connected via Cisco Fabric Extender Transceivers?

A. 100 m

B. 75 m

C. 150 m

D. 50 m

정답: A

문제12

What TCP/IP layer would handle UDP traffic flows?

A. internetwork

B. transport

C. network interface

D. physical

정답: B

문제13

HOTSPOT

정답:

Explanation:
Use the show vlan command to see the number of VLANs configured in the 1006-4094 range.

문제14

When deploying 10BASE-2 Ethernet, what is the maximum cable length?

A. 150 meters

B. 185 feet

C. 100 feet

D. 185 meters

E. 150 feet

F. 100 meters

정답: D

설명: (Fast2test 회원만 볼 수 있음)

Cisco Introducing Cisco Data Center Networking - 640-911무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트