Cisco Implementing cisco ip routing - 642-902무료 덤프문제 풀어보기
What is the international standard for transmitting data over a cable system?
정답: D
설명: (Fast2test 회원만 볼 수 있음)
After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C.
The following output is shown:
RouterC#show ip eigrp traffic
IF-EIGRP Traffic Statistics for process 1 Hellos sent/received: 481/444 Updates sent/received: 41/32 Queries sent/received: 5/1 Replies sent/received: 1/4 Acks sent/received: 21/25 Input queue high water mark 2, 0 drops SIA-Queries sent/received: 0/0 SIA-Replies sent/received: 0/0 Approximately 25 minutes later, you issue the same command again. The following output is
shown:
RouterC#show ip eigrp traffic
IP-EIGRP Traffic Statistics for process 1 Hellos sent/received: 1057/1020 Updates sent/received: 41/32 Queries sent/received: 5/1 Replies sent/received: 1/4 Acks sent/received: 21/25 Input queue high water mark 2, 0 drops SIA-Queries sent/received: 0/0 SIA-Replies sent/received: 0/0 Approximately 25 minutes later, you issue the same command a third time. The following output is
shown:
RouterC#show ip eigrp traffic
IP-EIGRP Traffic Statistics for process 1 Hellos sent/received: 1754/1717 Updates sent/received: 41/32 Queries sent/received: 5/1 Replies sent/received: 1/4 Acks sent/received: 21/25 Input queue high water mark 2, 0 drops SIA-Queries sent/received: 0/0 SIA-Replies sent/received: 0/0
What can you conclude about this network?
The following output is shown:
RouterC#show ip eigrp traffic
IF-EIGRP Traffic Statistics for process 1 Hellos sent/received: 481/444 Updates sent/received: 41/32 Queries sent/received: 5/1 Replies sent/received: 1/4 Acks sent/received: 21/25 Input queue high water mark 2, 0 drops SIA-Queries sent/received: 0/0 SIA-Replies sent/received: 0/0 Approximately 25 minutes later, you issue the same command again. The following output is
shown:
RouterC#show ip eigrp traffic
IP-EIGRP Traffic Statistics for process 1 Hellos sent/received: 1057/1020 Updates sent/received: 41/32 Queries sent/received: 5/1 Replies sent/received: 1/4 Acks sent/received: 21/25 Input queue high water mark 2, 0 drops SIA-Queries sent/received: 0/0 SIA-Replies sent/received: 0/0 Approximately 25 minutes later, you issue the same command a third time. The following output is
shown:
RouterC#show ip eigrp traffic
IP-EIGRP Traffic Statistics for process 1 Hellos sent/received: 1754/1717 Updates sent/received: 41/32 Queries sent/received: 5/1 Replies sent/received: 1/4 Acks sent/received: 21/25 Input queue high water mark 2, 0 drops SIA-Queries sent/received: 0/0 SIA-Replies sent/received: 0/0
What can you conclude about this network?
정답: B
설명: (Fast2test 회원만 볼 수 있음)
To configure 6to4 on a dual-stack edge router. Which three of the following are valid in 6to4 Tunneling configuration? (Choose three)
정답: A,B,F
설명: (Fast2test 회원만 볼 수 있음)
Above is the output from show ip bgp neighbors command.

What is line 21 stating about the BGP connection?

What is line 21 stating about the BGP connection?
정답: B
설명: (Fast2test 회원만 볼 수 있음)
Given the network diagram.

Which address would successfully summarize only the networks seen?

Which address would successfully summarize only the networks seen?
정답: F
설명: (Fast2test 회원만 볼 수 있음)
Refer to the exhibit.

When you examine the routing tables of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing table. You are also not able to see the R4 Ethernet subnet on the R1 routing table.
Which two configuration changes should be made to resolve this issue? Select the routers where the configuration change will be required, and select the required EIGRP configuration command(s). Choose two answers. (Choose two.)

When you examine the routing tables of R1 and R4, you are not able to see the R1 Ethernet subnet on the R4 routing table. You are also not able to see the R4 Ethernet subnet on the R1 routing table.
Which two configuration changes should be made to resolve this issue? Select the routers where the configuration change will be required, and select the required EIGRP configuration command(s). Choose two answers. (Choose two.)
정답: A,D
설명: (Fast2test 회원만 볼 수 있음)
Which statement is true concerning 6to4 tunneling?
정답: A
설명: (Fast2test 회원만 볼 수 있음)
Refer to the exhibit.

Which statement is true?

Which statement is true?
정답: D
설명: (Fast2test 회원만 볼 수 있음)
Refer to the diagram. Which OSPF configuration command is required to configure Area 3 as a totally stubby area?


정답: B
설명: (Fast2test 회원만 볼 수 있음)
Refer to the exhibit.

A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?

A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?
정답: B
Refer to the exhibit.

Which interoperability technique implemented on the router would allow Host-1 to communicate with Host-2?

Which interoperability technique implemented on the router would allow Host-1 to communicate with Host-2?
정답: A
설명: (Fast2test 회원만 볼 수 있음)
A network administrator has enabled OSPF across an NBMA network and has issued the command ip ospf network nonbroadcast. Given those facts, which two statements are true? (Choose two.)
정답: A,E
설명: (Fast2test 회원만 볼 수 있음)
DRAG DROP


정답:

Explanation:
