[2026] Cisco Troubleshooting Cisco Data Center Unified Fabric (DCUFT)

문제1

An administrator wants to combine the advantages of a trunking F port and an F port channel.
Which command on a Cisco MDS switch should be used to enable this?

A. port-channel trunk

B. feature fport-channel-trunk

C. feature trunking-fport

D. feature fport-trunk

E. enable port-channel

정답: B

문제2

When you ping your new Cisco Nexus 7010 Switch, you see this output:
!!...!!...!!...!!...!!...
What could be the problem?

A. Traffic may be taking a bad route through the network.

B. The switch has high CPU utilization.

C. HSRP is flapping.

D. CoPP is rate-limiting the pings.

정답: D

문제3

The traffic across your port channels seems to be favoring one link over the other. How can you adjust the load-balancing policy to include source and destination MAC addresses, IP address, and TCP port?

A. kcdc-5010-1(config-if)# port-channel load-balance ethernet source-dest-port

B. kcdc-5010-1(config-if)# port-channel load-balance ethernet source-dest mac ip port

C. kcdc-5010-1(config)# port-channel load-balance ethernet source-dest mac ip port

D. kcdc-5010-1(config)# port-channel load-balance ethernet source-dest-port

정답: D

문제4

On the Cisco Nexus 7000 Series Switch, what could be the reason why the (config- vlan)#private-vlan primary command fails?

A. The interface is in the wrong VRF.

B. You are using a reserved VLAN ID.

C. The VLAN does not exist.

D. There are not enough resources in the VDC.

E. The VLAN is a secondary VLAN.

F. The PVLAN feature is not enabled.

정답: F

문제5

Which statement is true regarding Cisco FabricPath?

A. Cisco FabricPath is only available on Cisco Nexus 7010 Switches with the Supervisor 2 engine.

B. If the Cisco FabricPath feature is not installed, the fabricpath keyword will be available in the feature-set command.

C. It is necessary to first install the Cisco FabricPath feature set in the default VDC.

D. Cisco FabricPath cannot be disabled explicitly for a specific VD

정답: C

문제6

Refer to Exhibit.

You configure a Cisco Nexus 5000 in NPV mode to enable multiple servers to log in over a single link to the NPV switch. Which option describes why the vfc interface is stuck on
"initializing" state?

A. The upstream switch does not have "feature npiv" enabled.

B. The load balancing is configured incorrectly on the Cisco Nexus 5000 switch.

C. The Version of code does not support the NPV feature.

D. The Cisco Nexus 5000 switch does not have "feature npv" enabled.

정답: A

문제7

Refer to the exhibit.

A customer is having a problem getting NPV to work. What is causing the problem?

A. The core NPV switch port is in a shutdown state.

B. The core NPV switch port is not an F port.

C. The core NPV switch port is not configured on the other end.

D. The core NPV switch port is not configured on both ends.

E. The core NPV switch ports are in the wrong domain.

정답: B

Cisco Troubleshooting Cisco Data Center Unified Fabric (DCUFT) - 642-980무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트