API Source Inspector Electrical Equipment - API-SIEE무료 덤프문제 풀어보기

A. A dial indicator is oriented vertically and zeroed prior to base bolt tightening with a reading taken after tightening to confirm movement is within tolerance

B. Mounting bolt torque is verified with a calibrated torque wrench with no visible gaps observed between the foot and base interface

C. Feeler gauges are used at the foot to base interface to verify gap tolerance has not been exceeded

D. After torquing mounting bolts, a vertically oriented, zeroed, dial indicator is attached to each foot and a reading taken after loosening of the bolt torque to verify movement is within tolerance

A. Identify the presence of fault current flow through the circuit breaker

B. Locate the position of the charging mechanism

C. Indicate whether power is available to the circuit breaker

D. Prevent the release of the stored energy unless the mechanism has been fully charged

A. on the rear door of the low voltage motor control center.

B. on the wireway to prevent opening the wireway on the motor control center.

C. on the external operating handle.

D. on the door to prevent opening the combination starter door.

A. accepted after signatures are verified.

B. accepted after clarification.

C. rejected at the discretion of the source inspector.

D. cause for immediate rejection.

A. Class I Division 2.

B. Class I Zone 0.

C. Class I Zone 2.

D. Class I Zone 1.

A. One day

B. One hour

C. One second

D. One minute

A. API 546

B. IEEE 841

C. IEEE 141

D. NFPA 70