NFPA Certified Water-Based Systems Professionals - CWBSP무료 덤프문제 풀어보기

Where must a diesel engine driven fire pump's fuel tank be located for areas subject to temperatures below 32° F (0°#)?

정답: B
설명: (Fast2test 회원만 볼 수 있음)
If a 2,000 ft2 (186 m2) design area is selected, what design density is required for standard spray, high temperature sprinklers protecting Class IV commodities on a back-to-back shelf storage configuration to 14 ft (4.26 m)?

정답: A
설명: (Fast2test 회원만 볼 수 있음)
A fire pump must produce at least what percentage of its rated pressure at the 150% flow condition?

정답: A
설명: (Fast2test 회원만 볼 수 있음)
What is the minimum calculated design area for a dry system protecting a light hazard attic space with a roof slope exceeding a rise of 2 units in a run of 12 units and a height at the peak of 10 ft (3 m) above the bottom of the truss using quick response sprinklers?

정답: C
설명: (Fast2test 회원만 볼 수 있음)
The contract document states that the fire sprinkler system must be capable of protecting Cartoned Nonexpanded Group A plastic stored on wood pallets to a height of 25 ft (7.6 m) under a 35 ft (10.7 m) high ceiling using K16.8 (240) ESFR sprinklers. What is the minimum operating pressure?

정답: A
설명: (Fast2test 회원만 볼 수 있음)
Which Occupancy Classification is a machine shop considered?

정답: B
설명: (Fast2test 회원만 볼 수 있음)
What is the minimum exposed barrel length for a dry sprinkler barrel exposed to 50°F (10#) when the discharge end is in an environment of -30°F (34#)?

정답: B
설명: (Fast2test 회원만 볼 수 있음)
In NFPA 13R, shadowed areas shall be permitted in the protection area of a pendant or upright sprinkler as long as the cumulative dry areas do not exceed

정답: C
설명: (Fast2test 회원만 볼 수 있음)
An existing building with an existing sprinkler system is constructed with 26 in. (660 mm) beams framed into girders spaced on 7 ft (2.1 m) centers. What is the maximum distance permitted below the ceiling or roof deck if standard upright sprinklers are positioned in the center of each section?

정답: D
설명: (Fast2test 회원만 볼 수 있음)
What piping material is acceptable for the suction and discharge piping pressure maintenance pumps?

정답: B
설명: (Fast2test 회원만 볼 수 있음)

우리와 연락하기

문의할 점이 있으시면 메일을 보내오세요. 12시간이내에 답장드리도록 하고 있습니다.

근무시간: ( UTC+9 ) 9:00-24:00
월요일~토요일

서포트: 바로 연락하기 

English Deutsch 繁体中文 日本語