구매전 덤프 샘플문제 다운

352-011덤프를 구매하기전에 사이트에서 해당 덤프의 무료샘플을 다운받아 덤프품질을 체크해보실수 있습니다. Cisco Certified Design Expert Practical Exam덤프를 구매하시면 구매일로부터 1년내에 덤프가 업데이트된다면 업데이트된 버전을 무료로 제공해드립니다.만약 352-011덤프를 구매하고 공부한후 352-011시험에서 떨어지면 60일내 주문은 덤프비용 전액을 환불해드려 고객님의 이익을 최대한 보장해드립니다.

우선 시험센터에서 정확한 시험코드를 확인하고 그 코드와 동일한 코드로 되어있는 덤프를 구매하셔서 덤프에 있는 문제와 답을 기억하시면 시험을 쉽게 패스하실수 있습니다. 352-011덤프는 가장 최근 기출문제를 기준으로 제작되기에 Cisco Certified Design Expert Practical Exam시험문제가 변경되지 않는한 100%에 가까운 적중율을 보장해 시험에서 패스하는데 가장 좋은 동반자로 되어드릴것입니다.

DOWNLOAD DEMO

퍼펙트한 시험대비자료

352-011 최신덤프는 352-011실제시험의 모든 범위를 커버하고 있고 모든 시험유형이 포함되어 있어 시험대비 공부의 완벽한 선택입니다.최신버전 덤프는 Cisco Certified Design Expert Practical Exam시험문제에 근거하여 만들어진 시험준비 공부가이드로서 학원공부 필요없이 덤프공부 만으로도 시험을 한방에 패스할수 있습니다.자격증을 취득하시면 국제적으로 인정받기에 취직이나 승진 혹은 이직에 힘을 가해드립니다.

시험전 20-30시간의 공부시간

자격증을 취득하려면 오랜시간동안 시험공부를 해야 한다고 생각하시는 분들이 많습니다. 하지만 이는 352-011덤프가 아닌 다른 공부방법에 적용되는 보편적인 생각일뿐입니다. 352-011덤프를 공부하시는데는 20~30시간만 사용하시면 됩니다.덤프만 있으면 다른 공부자료는 필요하지 않습니다.덤프는 Cisco Certified Design Expert Practical Exam시험문제의 모든 범위와 유형을 포함하고 있어 352-011덤프에 있는 문제와 답만 기억하시면 시험문제가 변경되지 않는다면 합격을 예약한것과 같다고 보시면 됩니다.

최신 CCDE 352-011 무료샘플문제:

1. An enterprise network has two core routers that connect to 200 distribution routers and uses full-mesh iBGP peering between these routers as its routing method. The distribution routers are experiencing high CPU utilization due to the BGP process. Which design solution is the most effective?

A) Implement route reflectors on the two core routers
B) Increase the memory on the distribution routers
C) Increase the memory on the core routers
D) Implement eBGP between the core and distribution routers
E) Increase bandwidth between the core routers

2. What is design considerations of policy-based routing?

A) It can create microloops during network reconvergence
B) It uses RSVP to differentiate traffic flows, so queuing mechanisms can prioritize them
C) It routes traffic destined to a set of users through different exit points
D) It decreases failure detection time

3. You are designing the QoS features for a large enterprise network that includes DMVPN. In which situation should you use the QoS pre-classify feature?

A) When you are marking packets with the DSCP bits
B) When the QoS policy cannot be based on DSCP bits
C) When your service provider requires the DSCP bits be set
D) When you are marking packets with the ToS bits

4. Refer to the exhibit.

A customer interconnected hundreds of branch offices into a single DMVPN network, with the HUB in the main data center. Due to security policies, the customer requires that the default route for all Internet traffic from the users at the branches must go through the tunnel and the only connections that are allowed to and from the branch router over the local internet circuit are the DMVPN tunnels. Which two combined actions must you take on the branch router to address these security requirements and keep the solution scalable?
(Choose two)

A) Implement a zone-based firewall that allows only IPsec-related traffic from zone UNTRUSTED to zone TRUSTED
B) Place the WAN interface in a front-door VRF, leaving the tunnel interface in the default routing instance
C) Use a floating default route with the preferred path over the tunnel and a backup path over the Internet natively
D) Add a host route for the public IP address of each remote branch and HUB routers that points directly to the local ISP, and add a default route that points to the tunnel
E) Protect the WAN interface by an inbound ACL that permits only IPsec-related traffic

5. Refer to the exhibit.

Company A is running a single-area OSPF, and Company B is running RIP as the IGP with no overlapping IP address spaces. Company A has just acquired Company B and both networks must be merged. Which three design components are recommended to guarantee connectivity and redundancy between the two networks?
(Choose three.)

A) Implement an ACL on Router A and Router B to prevent OSPF external routes from being installed in the OSPF database.
B) Increase the administrative distance to 130 for the OSPF external prefixes on Router A and Router B.
C) Enable mutual redistribution between OSPF and RIP on one border router.
D) Filter external routes on Router A and Router B based on route tags.
E) Enable mutual redistribution between OSPF and RIP on Router A and Router B using route tags.

질문과 대답: