[2026] CTTAM Technical Examination - Civil Engineering Technology C.E.T - Civil-Engineering-Technology 무료 시험 문제

문제1

Why would an owner require COR certification from a contractor?

A. To ensure that a contractor has a quality safety management program in place

B. To ensure that a contractor has a good workplace safety record

C. To ensure that a contractor is generally in compliance with workers' compensation regulations

D. To ensure that a contractor has first aid personnel on staff

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제2

A cologist is required to inspect the installation of a sanitary service pipe to confirm the slope. The technologist measures an elevation of 705.667 at the end of the service and 705.202 at the main. The horizontal measurement from the main to the end of the service is 22.10 m. What is the slope of the pipe?

A. 2.0%

B. 2.5%

C. 2.1%

D. 1.5%

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제3

Which of the following tests would most likely be used to determine if engineered fill was placed to meet contract specifications?

A. Triaxial compression test

B. Moisture content check

C. Compaction test

D. Sieve analysis

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제4

A contractor is using a compactor on a hot and dry day and quickly compacts a dry 300 mm thickness of sub- base without adding water. The soil is near optimum moisture. A civil engineering technologist completes compaction tests and finds that specifications have not been achieved. What should be done?

A. Continue with base placement and compaction.

B. Strip the sub-base down to sub-grade and import new material.

C. Re-compact and retest the soil.

D. Add water and re-compact.

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제5

Whatto determine the compressive strength of concrete?

A. Slump test

B. Cylinder test

C. Sieve test

D. Air test

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제6

EXCERPT FROM MUNICIPAL BYLAW 1234 - ZONING
Section 3: Single family zone
3.1 All dwellings shall house one family.
3.2 All dwellings shall have a minimum main floor area of 120 m².
3.3 All dwellings shall be constructed a minimum of 10.0 m from the front property line, 15.0 m from the rear property line, and 1.5 m from the side property lines.
3.4 An application that does not fulfill the above requirements shall be referred to Council.

A. Refer the application to Council because it does not meet the requirements.

B. Approve the application because it meets all requirements.

C. Reject the application because one of the side yard dimensions and the main floor area are not sufficient.

D. Reject the application because the rear yard setback is too large.

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제7

Which of the following should be performed to determine the cumulative effect of a land development project on land, air, and water?

A. Aerial surveys

B. Environmental assessment

C. Preliminary surveys

D. Urban services design

정답: B

설명: (Fast2test 회원만 볼 수 있음)

CTTAM Technical Examination - Civil Engineering Technology C.E.T - Civil-Engineering-Technology무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트