[2026] EMC Specialist - Implementation Engineer, Campus Networking

문제1

A network administrator has configured a 4-port port-channel between two Dell EMC Campus networking switches. The physical interfaces show as administratively up and operationally up on both switches. However, the port-channel shows as operationally up on Switch A and operationally down on Switch B.
What is a potential reason for the inconsistent port-channel state?

A. Ports in the port-channel on Switch A are all the same speed but the ports in the port-channel on Switch B are a mix of speeds

B. N-Series supports a maximum number of physical interfaces that can be included in port-channels on a per-device basis

C. Switch A is configured using channel-group # mode on and Switch B is configured using channel- group # mode auto

D. Switch A is configured to use dynamic port-channels and Switch B is configured to use static port- channels

정답: C

문제2

If a VRRP Master router is rebooted, what is the default behavior once it comes back online?

A. Original VRRP Master will take back control of the Master role

B. Original VRRP Backup will retain the Master role

C. An election occurs to determine which router will have the Master role

D. VRRP Master role is determined by the router with the lowest MAC address

정답: A

문제3

Match the DSCP class selectors with their description.

정답:

문제4

Refer to the exhibit.

A network administrator has created an ACL to block broadcast traffic to their server on port Gi1/0/1. Why is the ACL not functioning as desired?

A. ACLs do not support broadcast traffic

B. Destination address mask is incorrect

C. ACL is not applied in the correct direction

D. Destination IP address is incorrect

정답: C

문제5

How does the weighted Queue Scheduler prioritize packets?

A. Weights are calculated based on the number of packets

B. Weight is assigned to each port

C. Weights are used to calculate the number of bytes

D. Scheduler prioritizes weighted queues over any strict queues

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제6

What is a recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?

A. Spanning tree must be disabled

B. Link must contain multiple interfaces

C. Link must be a trunk port

D. Spanning tree must be enabled

정답: D

문제7

Refer to the Exhibit.

A network administrator needs to configure the switches to allow traffic to communicate from Host 1 to Host 2. Which recommended switch port mode should the interconnecting switch ports be configured?

A. Access

B. Hybrid

C. VLAN Stacking

D. Trunk

정답: D

EMC Specialist - Implementation Engineer, Campus Networking - DES-5121무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트