주의사항: HP，EMC 인증사 덤프는 불합격시 덤프구매비용의 50%만 환불가능합니다.

퍼펙트한 시험대비자료

HP0-Y45 최신덤프는 HP0-Y45실제시험의 모든 범위를 커버하고 있고 모든 시험유형이 포함되어 있어 시험대비 공부의 완벽한 선택입니다.최신버전 덤프는 Architecting HP Network Solutions시험문제에 근거하여 만들어진 시험준비 공부가이드로서 학원공부 필요없이 덤프공부 만으로도 시험을 한방에 패스할수 있습니다.자격증을 취득하시면 국제적으로 인정받기에 취직이나 승진 혹은 이직에 힘을 가해드립니다.

구매전 덤프 샘플문제 다운

HP0-Y45덤프를 구매하기전에 사이트에서 해당 덤프의 무료샘플을 다운받아 덤프품질을 체크해보실수 있습니다. Architecting HP Network Solutions덤프를 구매하시면 구매일로부터 1년내에 덤프가 업데이트된다면 업데이트된 버전을 무료로 제공해드립니다.만약 HP0-Y45덤프를 구매하고 공부한후 HP0-Y45시험에서 떨어지면 60일내 주문은 덤프비용 전액을 환불해드려 고객님의 이익을 최대한 보장해드립니다.

시험전 20-30시간의 공부시간

자격증을 취득하려면 오랜시간동안 시험공부를 해야 한다고 생각하시는 분들이 많습니다. 하지만 이는 HP0-Y45덤프가 아닌 다른 공부방법에 적용되는 보편적인 생각일뿐입니다. HP0-Y45덤프를 공부하시는데는 20~30시간만 사용하시면 됩니다.덤프만 있으면 다른 공부자료는 필요하지 않습니다.덤프는 Architecting HP Network Solutions시험문제의 모든 범위와 유형을 포함하고 있어 HP0-Y45덤프에 있는 문제와 답만 기억하시면 시험문제가 변경되지 않는다면 합격을 예약한것과 같다고 보시면 됩니다.

우선 시험센터에서 정확한 시험코드를 확인하고 그 코드와 동일한 코드로 되어있는 덤프를 구매하셔서 덤프에 있는 문제와 답을 기억하시면 시험을 쉽게 패스하실수 있습니다. HP0-Y45덤프는 가장 최근 기출문제를 기준으로 제작되기에 Architecting HP Network Solutions시험문제가 변경되지 않는한 100%에 가까운 적중율을 보장해 시험에서 패스하는데 가장 좋은 동반자로 되어드릴것입니다.

DOWNLOAD DEMO

최신 HP ExpertONE Certification HP0-Y45 무료샘플문제:

1. A customer has a solution that continuously backs up date for critical services to a disaster recovery site. The customer requires a one hour recovery point objective (RPO) and a 90 minute recovery time objective (RTO). The network architect is scoping the bandwidth requirements and has used perfmon to analyze the write throughput for the critical service over a month. The results are:
-Peak throughput= 2000 Mbps -Average throughput = 500 Mbps -Highest average throughput in hour increments =1000 Mbps -High average throughputin 90 minuteincrements =750 Mbps
What is the bandwidth requirement for the continuous backup?

A) 750 Mbps
B) 2000 Mbps
C) 1000 Mbps
D) 500 Mbps

2. Refer to the exhibit.

A network architect has designed the topology in the exhibit. The Gigabit links between layer and the core uses OM3 grade multi-mode fiber between 100m and 150m long.
The solution is for an enterprise customer whose employees use mostly HTTP-based application and have medium utilization needs.
What should the network architect do to resolve a potential issue?

A) Replace the modular switches at the access layer with switches that support stacked meshing.
B) Remove the distribution layer since it is not needed on this environment.
C) Add more links between each modular switch at the access layer and its distribution layer switch.
D) Add more bandwidth between each pair of distribution layer switches and the core switches.

3. HOTSPOT
Match the HP power saving technology with the benefit that it provides.

4. Refer to the exhibit.

The branch routers have E1 lines into the Frame Relay service provider network. The exhibit shows just one branch but the network actually has 30 branches. The Hp 6600 Services routers, which are the area border routers (ABRs), have E3 lines into the Frame Relay network.
The routers in the exhibit implement Open Shortest Path First (OSPF). They enable OSPF on networks as follows:
-In the area 2, OSPF is enabled on network 10.2.0.0/16 -In area 0, OSPF is enabled on network 10.0.0.0/16
The customer requires resilience at the WAN core. Which Design Change best supports that requirement?

A) At each branch, add a redundant link between the switch and the router.
B) Add a Gigabit link between the HP 6600 Series routers with a network in area 0 and area 2.
C) On each branch router, add a floating static route to one of the ABRs in case the OSPF solution fails.
D) Place the HP 6600 Series routers in an intelligent Resilient Framework (IRF) group.

5. Refer to the exhibit.

A network architect is planning a voice over IP (VoIP) solution for a customer. A computer connects to each VoIP phone, which is Link Layer Discovery Protocol Media Extensions (LLDPMED) capable and supports 802.1X. The Phone then connects to the Ethernet jack. The design currently calls for edge ports to enforce 802.1x to a wireless Network Policy Server (NPS), and RADIUS policies assign users to VLANs based on their identity.
How should the network architect plan VLANs for the VoIP phones?

A) Disable 802.1X on the phones so that they are placed in the same reason, and use the same VLAN, as the authenticated user on the computer.
B) Plan a voice VLAN for each IRF group. Use LLDP.MED and the voice VLAN definition on edge ports to assign the VLAN to phones.
C) Plan a voice VLAN that is associated with dynamic user VLAN. Make sure that RADIUS policies specify that as the tagged VLAN.
D) Make sure that RADIUS policies assign each VoIP phone to the same VLAN that is expected for users.

질문과 대답: