[2026] Fortinet FCSS - SD-WAN 7.4 Architect - FCSS_SDW

문제1

You are tasked with configuring ADVPN 2.0 on an SD-WAN topology already configured for ADVPN. What should you do to implement ADVPN 2.0 in this scenario?

A. Delete the existing ADVPN configuration and configure ADVPN 2.0.

B. Update the IPsec tunnel configurations on the hub.

C. Update the SD-WAN configuration on the branches.

D. Update the IPsec tunnel configuration on the branches.

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제2

Refer to the exhibit, which shows output of the command diagnose sys sdwan health-check status collected on a FortiGate device.

Which two statements are correct about the health check status on this FortiGate device?
(Choose two.)

A. The interface T_INET_1 missed one SLA target.

B. There is no SLA criteria configured for the health-check Level3_DNS.

C. The health-check VPN_PING orders the members according to the measured jitter.

D. The interface T_INET_0 missed three SLA targets.

정답: A,B

문제3

Your FortiGate is in production. To optimize WAN link use and improve redundancy, you enable and configure SD-WAN.
What must you do as part of this configuration update process?

A. Purchase and install the SD-WAN license, and reboot the FortiGate device.

B. Replace references to interfaces used as SD-WAN members in the firewall policies.

C. Replace references to interfaces used as SD-WAN members in the routing configuration.

D. Disable the interface that you want to use as an SD-WAN member.

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제4

The administrator uses the FortiManager SD-WAN overlay template to prepare an SD-WAN deployment. Using information provided through the SD-WAN overlay template wizard, FortiManager creates templates ready to install on the spoke and hub devices.
What are the three templates created by the SD-WAN overlay template for a spoke device?
(Choose three.)

A. BGP template

B. CLI template

C. IPsec tunnel template

D. Static route template

E. Rules template

정답: A,C,E

설명: (Fast2test 회원만 볼 수 있음)

문제5

When a customer delegate the installation and management of its SD-WAN infrastructure to an MSSP, the MSSP usually keeps the hub within its infrastructure for ease of management and to share costly resources.
In which two situations will the MSSP install the hub in customer premises? (Choose two.)

A. The administrator expects a large volume of traffic between the branches.

B. The customer requires SIA with centralized breakout.

C. The majority of the branch traffic is directed to a corporate data center.

D. The customer expects a large amount of VoIP traffic.

정답: A,C

설명: (Fast2test 회원만 볼 수 있음)

문제6

Which statement describes FortiGate behavior when you reference a zone in a static route?

A. FortiGate ignores the static routes defined through members referenced in the zone.

B. FortiGate routes the traffic through the best performing member of the zone.

C. FoftiGate installs ECMP static routes for the first two members of the zone.

D. FortiGate installs a static route for each member in the zone.

정답: D

설명: (Fast2test 회원만 볼 수 있음)

문제7

Refer to the exhibit. The exhibit shows the health-check configuration on a FortiGate device used as a spoke. You notice that the hub FortiGate doesn't prioritize the traffic as expected.
Which two configuration elements should you check on the hub? (Choose two.)

A. The performance SLA has the parameter priority-out-slaconfigured.

B. This performance SLA uses the same members.

C. The performance SLA is configured with set embedded-measure accept.

D. The performance SLA uses the same criteria.

정답: C,D

설명: (Fast2test 회원만 볼 수 있음)

문제8

Refer to the exhibits. The exhibits show an SD-WAN event log, the member status, and the SD- WAN rule configuration.
Which two conclusions can you draw from the information shown? (Choose two.)

A. FortiGate updated the outgoing interface list on the rule so it prefers port2.

B. Port2 has a lower latency than port1.

C. The administrator configured the service ID 1 with the highest priority member for port2.

D. The administrator configured the SD-WAN rule ID 1 with the default strategy mode.

정답: A,B

설명: (Fast2test 회원만 볼 수 있음)

Fortinet FCSS - SD-WAN 7.4 Architect - FCSS_SDW_AR-7.4무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트