Juniper Data Center, Associate (JNCIA-DC) - JN0-281무료 덤프문제 풀어보기

A. inet.6

B. inet6.0

C. inet0.6

D. inet.0

A. It specifies the IP address of the directly connected device.

B. It instructs the device to looks up a static route's next-hop that is not directly connected.

C. It allows you to specify an independent route preference value for an additional next hop.

D. It instructs the device to verify the next-hop is reachable before activating the route.

A. Redundant Switching Tree Protocol

B. Resilient Switching Transport Protocol

C. Rapid Spanning Tree Protocol

D. Routing Switch Transport Protocol

A. Man-in-the-middle attack

B. Data decryption

C. Playback attacks

D. Hashing attacks

A. [edit interfaces]

B. [edit system]

C. [edit chassis]

D. [edit switch-options]

A. You must create an instance-type forwarding routing instance.

B. You must create a match filter.

C. You must create a security policy.

D. You must create an instance-type vrf routing instance.

E. You must create a RIB group.

A. To keep the topology structure of the network.

B. To log changes in network topology.

C. To maintain a list of OSPF neighbors.

D. To store OSPF routing tables.

A. Control-board

B. Routing-engine

C. PFE

D. Line card

A. 10.20.60.0/23

B. 10.20.100.0/24

C. 10.20.0.0/24

D. 10.20.0.0/16

A. Automatically generate routing entries.

B. Optimize the routing table size.

C. Increase the security of the routing process.

D. Implement policy-based routing decisions.

A. Addresses used in MPLS.

B. Unroutable addresses that are generally filtered by routers.

C. Special routes for interplanetary communication.

D. Addresses used for load balancing.

A. An access port can carry traffic for multiple VLANs.

B. A trunk port can carry traffic for multiple VLANs.

C. An access port carries traffic only for a single VLAN.

D. A trunk port is used exclusively for inter-switch links.