[2026] Juniper Mist AI Wireless, Specialist (JNCIS-MistAI-Wireless)

문제1

You have four actions presented to you by Marvis. Three of these actions are found under the AP category. Upon inspecting the category, you notice that the sub-categories in the AP category contain a lock symbol so that you cannot select any of the sub-categories to view the root cause.
In this scenario, which statement is correct?

A. You need to enable Marvis Minis.

B. A subscription is needed.

C. The issue was identified as an AP issue, but Marvis Actions could not find the actual root cause.

D. It takes more time for the root cause report to be prepared by Marvis Actions.

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제2

What is the primary purpose of Dynamic Packet Capture in Mist?

A. To automatically trigger and capture packets when Marvis detects an anomaly

B. To replace the need for spectrum analysis

C. To continuously capture all wireless traffic for storage

D. To configure QoS policies

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제3

What is the primary purpose of a Pre-Shared Key (PSK) with Multi-PSK in Mist WLAN configuration?

A. To assign a unique or group-specific pre-shared key to different users or device types on the same SSID

B. To disable WPA3 encryption

C. To require certificate-based authentication only

D. To broadcast multiple SSIDs from one radio

정답: A

설명: (Fast2test 회원만 볼 수 있음)

문제4

Marvis Minis verifies possible network problems in which order?

A. ARP, application, DNS, DHCP

B. DNS, DHCP, ARP, application

C. DHCP, ARP, DNS, application

D. application, DNS, ARP, DHCP

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제5

Administrators need to gather information regarding client dwell time and how clients move through a location. In this scenario, which real-time location service provides this capability?

A. optimize workflow

B. zone analytics

C. asset tracking

D. wayfinding

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제6

How much frequency does a DSSS channel use on the 2.4 GHz band?

A. 4 MHz

B. 12 MHz

C. 10 MHz

D. 22 MHz

정답: D

설명: (Fast2test 회원만 볼 수 있음)

문제7

Click the Exhibit button.

You are asked to deploy a new Juniper Mist Edge VM for your customer.
Referring to the exhibit, which three interfaces are required to accomplish this task? (Choose three.)

A. out-of-band

B. downstream

C. proxy

D. revenue

E. upstream

정답: A,B,E

설명: (Fast2test 회원만 볼 수 있음)

문제8

Which statement correctly describes adjacent channel interference (ACI)?

A. ACI has two or more access points operating on the 2.4 GHz band.

B. ACI has two or more access points operating on overlapping channels.

C. ACI has two or more access points operating on the same channel.

D. ACI has two or more access points operating on non-overlapping channels.

정답: B

설명: (Fast2test 회원만 볼 수 있음)

문제9

Which statement best describes Mist's approach to RRM (Radio Resource Management)?

A. It requires manual channel and power configuration by the administrator

B. It uses a centralized controller to recalculate channels every 24 hours

C. It continuously and dynamically optimizes channel and power settings using cloud-based AI

D. It only adjusts power levels and not channel assignments

정답: C

설명: (Fast2test 회원만 볼 수 있음)

문제10

You want a Juniper Access Point to remember its configuration in the event of a power failure.
Which parameter in the UI would you enable in the site configuration to satisfy this requirement?

A. Enable Local Status Page

B. Mesh

C. AP Uplink Monitoring

D. AP Config Persistence

정답: D

설명: (Fast2test 회원만 볼 수 있음)

Juniper Mist AI Wireless, Specialist (JNCIS-MistAI-Wireless) - JN0-452무료 덤프문제 풀어보기

우리와 연락하기

유용한 링크

최신 업데이트