Juniper Service Provider Routing and Switching - JN0-661무료 덤프문제 풀어보기
-- Exhibit -
-- Exhibit --
Click the Exhibit button.
Referring to the exhibit, you must advertise the 200.100.0.0/16 routes from Site 2 to Site 1, but R3 is not currently advertising any BGP routes to R2.
Why is this happening?
-- Exhibit --
Click the Exhibit button.
Referring to the exhibit, you must advertise the 200.100.0.0/16 routes from Site 2 to Site 1, but R3 is not currently advertising any BGP routes to R2.
Why is this happening?
정답: D
In a carrier-of-carrier VPN model, which type of network layer reachability information is used for the MP-BGP signaling between CE and PE routers?
정답: D
설명: (Fast2test 회원만 볼 수 있음)
You are asked to configure PIM-SM in your network. Your implementation must allow for load sharing between redundant RPs and, should an RP failure occur, the RP failover time should be minimized.
Which two configuration tasks are required in this scenario? (Choose two.)
Which two configuration tasks are required in this scenario? (Choose two.)
정답: B,D
설명: (Fast2test 회원만 볼 수 있음)
Refer to the exhibit.
Which statement is true?
Which statement is true?
정답: D
Click the Exhibit button.
ISP1 has created an L3VPN to connect CE1 and CE2. The PE-CE routing protocol is OSPF.
Referring to the exhibit, which technology will allow CE1 to receive Type 1 and Type 2 LSAs from CE2?
ISP1 has created an L3VPN to connect CE1 and CE2. The PE-CE routing protocol is OSPF.
Referring to the exhibit, which technology will allow CE1 to receive Type 1 and Type 2 LSAs from CE2?
정답: B
설명: (Fast2test 회원만 볼 수 있음)
-- Exhibit -
-- Exhibit --
Click the Exhibit button.
Your network has multiple LSPs between Router A and Router B, as shown in the exhibit.
You add a new LSP between these routers with the following parameters:
LSP5: 20 Mbps; Priority 2 2
Assuming no link has 20 Mbps available, which LSPs are candidates for preemption by LSP5? (Choose two.)
-- Exhibit --
Click the Exhibit button.
Your network has multiple LSPs between Router A and Router B, as shown in the exhibit.
You add a new LSP between these routers with the following parameters:
LSP5: 20 Mbps; Priority 2 2
Assuming no link has 20 Mbps available, which LSPs are candidates for preemption by LSP5? (Choose two.)
정답: B,C
An L1 router has formed an adjacency with an L1-L2 router.
Under which condition will the L1-L2 router set the attach bit in its Level 1 link-state PDUs?
Under which condition will the L1-L2 router set the attach bit in its Level 1 link-state PDUs?
정답: C
설명: (Fast2test 회원만 볼 수 있음)
You are asked to deploy VPLS in your network as a new service for several customers and must identify the configuration and provisioning requirements. Which two statements are correct? (Choose two.)
정답: A,C