Motorola Solutions Deploy WLAN Solutions - MSC-122무료 덤프문제 풀어보기
You are utilizing a passive site survey tool to verify the results of a survey done with predictive software. Which of the following tasks can these tools perform?
정답: D
You are positioning an AP on the 4th floor of a multi floor building. The site survey indicated that there are concrete floors, a concrete block wall on one side of the room, and a sheetrock wall on the other end of that room. Which of these obstacles will attenuate the signal the most?
정답: B
When mounting an antenna on a metal wall, what special considerations do you have to take into account regarding RF propagation (select TWO)?
정답: B,D
You are in the Network Operations Center and are attempting to connect to an newly installed RFS6000 switch in a remote facility by using a Telnet session between your computer and the switch. Each time you attempt to connect to the switch your telnet session fails. You have verified that the switch is installed and on the network by using the ping command. What should your next step be in troubleshooting this issue?
정답: B
What is the amount of power measured in Watts that is required to power all three radios on a Tri-radio AP-7131N along with GE1&2 at 10/100/1000?
정답: B
You have configured a Motorola RFS controller with multiple VLANs. You have configured the native VLAN as VLAN 6, management traffic to use VLAN 8, voice traffic to flow over VLAN 18, and guest Internet access as VLAN 21. On which VLAN will untagged frames be placed after they arrive at the controller?
정답: B
As part of the Acceptance Testing you will need to validate that the failover design of your RFS controllers is working. Your configuration is two RFS7000 controllers. You decide to check your failover status by inspecting the System Status LEDs on the primary RFS7000 controller. If your system is configured and functioning correctly what is the expected current state of the System Status 2 LED? Please use the Status exhibit at the bottom.
정답: C
You are using spectrum analysis to verify that the implementation of the WLAN matches the results anticipated by the site survey and experience interference in all bands. Which of the following devices would cause all-band interference for a WLAN?
정답: D
Following the installation of a WiNG multi-floor, hospital deployment using RFS controllers and independent dual-radio APs, the WLAN administrator informs you that management has requested an additional WLAN. This additional WLAN will be used to allow temporary, authenticated visitors, such as visiting physicians and administrative personnel to share Internet connectivity and have some access to basic intranet resources such as printers. The guests will be assigned temporary logins which will be authenticated through RADIUS. Which of the following would be the best way to configure this WLAN?
정답: D