HP Aruba Certified Campus Access Mobility Expert Written - HPE7-A07무료 덤프문제 풀어보기

What should be defined on the Edge-1 to establish valid BGP routing between agg-sw1 and agg-sw2 using BGP protocol using the IP addresses above?

정답: A
설명: (Fast2test 회원만 볼 수 있음)
An engineer has applied the above configuration to R1 and R2. However, the router's OSPF adjacency never progresses past the "EXSTART/DR" state.

Which configuration action on either router will allow R1 and R2 to progress past the "EXSTART/DR" state?

정답: C
설명: (Fast2test 회원만 볼 수 있음)
What is the recommended configuration to ensure link aggregation is consistent in a campus topology using VSX with two aggregation switches and downlinks to access switches?

정답: D
설명: (Fast2test 회원만 볼 수 있음)
Exhibit.

What is me expected behavior for ARP traffic sent from H1?

정답: B
설명: (Fast2test 회원만 볼 수 있음)
Exhibit.


After configuring VRRP between sw-1 and SW-2. you notice that both switches are showing as active. What could be the reason for this issue?

정답: A
설명: (Fast2test 회원만 볼 수 있음)
A customer is planning to add loT devices that connect wirelessly to the existing 802.1X SSID. The customer will use HPE Aruba Networking ClearPass to authenticate the loT devices by MAC address but other devices will still need to authenticate by only 802.1X.
Refer to the exhibit.

The customer provided the current configuration and reported their non-IoT 802.1X devices are no longer able to connect. Which configuration change can be made to fix the issue?

정답: D
설명: (Fast2test 회원만 볼 수 있음)
Refer to the exhibit.

To which devices has AP-1 established tunnels?

정답: B
설명: (Fast2test 회원만 볼 수 있음)

우리와 연락하기

문의할 점이 있으시면 메일을 보내오세요. 12시간이내에 답장드리도록 하고 있습니다.

근무시간: ( UTC+9 ) 9:00-24:00
월요일~토요일

서포트: 바로 연락하기 

English Deutsch 繁体中文 日本語